Elinchrom RX 1200 Betriebsanleitung PDF herunterladen (Seite 8)

Charge Ready Beep (9)

Press this touch (9) to activate the acoustic signal

Once recycled, an acoustic signal (beep) indicates that the power pack is ready.

Open Flash (5)

When the green LED is illuminated the ash may be released manually.

The release is blocked during charging, but not when the unit discharges.

The integrated discharge system is protected by a thermic cut out.

In order to restrict the heating of the unit, we suggest to release a ash with the green

touch (5) "READY" after each strong reduction of power (more the 2f-stop).

This allows to release the excess of energy in the ash tube.

You will gain time and extend the life span of your power packs.

Slow Charge (11)

The green LED indicates that the slow charge function is selected.

This position is recommended if the mains line capacity is limited for the standard fast-

charge mode.

The Photocell (8) is activated when the green LED (4) is illuminated. When switched on,

the pack can be remotely triggered by another ash unit!

The Digital RX photocell is specially designed to work under ambiant light situation in your

studio, direct light or other strong lights may reduce the sensitivity of the cell.

In difcult situations e.g. blinding, sunlight or obstacles, the additional cell with 5 m cord

(extensions available) solves most problems.

Photocell On/Off (6)

Synchronisation Socket (10)

Standard / Elinchrom Amphenol socket or 3.5 mm mini-jack (10).

N.B. Do not link ELINCHROM power packs via sync cable to other brands.

ELINCHROM uses low voltage (5V) for security reasons. Other systems may have

higher voltages and could cause damages.

Flashheads Control button (18 and 19)

These buttons switches on the ashhead sockets.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

Keine Kommentare

Elinchrom RX 1200 Betriebsanleitung Seite 8