Elinchrom RX 1200 Betriebsanleitung PDF herunterladen (Seite 9)

This unit is protected by security device.

Should the unit not work properly, due to a defective power component,

the security would instantly stop the charge.

The power pack requires a check up at a technical Elinchrom service.

Overvoltage security

Relation of power range between the outlets

Guide aperture is based on the " Digital S or Digital SE " lamphead and the 50° reector,

distance 1 m/3.3 ft and lm ISO 100/21 DIN.

Digital 1200 RX Digital 2400 RX

Scale Ws f-stop Scale Ws f-stop Power

7.5 1200 (128) 8.5 2400 (180) 1/1

6.5 600 (90) 7.5 1200 (128) 1/2

5.5 300 (64) 6.5 600 (90) 1/4

4.5 150 (45) 5.5 300 (64) 1/8

3.5 75 (32) 4.5 150 (45) 1/16

2.5 37.5 (22) 3.5 75 (32) 1/32

Main Supply

While the MAINS SWITCH (3) is switched OFF (not illuminated), rmly push in the plug of the

original ELINCHROM mains cord (1).

Standard type 5 x 20 mm, 16 AT (tempered). Before exchanging a blown fuse, switch off the unit

and remove mains cable. Depress and turn the fuse holder anti-clockwise 1/8th and remove it.

If the new fuse blows immediately upon reconnection return the pack to an ELINCHROM service

centre for a check-up.

(N.B. Check correct value of the fuse: 16 AT).

Fuse

Fuses for ashheads

Use only FAST BLOW FUSES, type 5 x 20 mm corresponding to the label on each ashhead.

Different modelling lamps require corresponding fuses. Slow blow fuses will not protect the

modelling lamp. The fast blow fuse will protect the triac of the modelling lamp circuit, the

lamp and therefore the ash tube.

Modelling Lamp-

switch

Fuse

W 110V 240V

200 2 AF 2 AF

250 5 AF 2.5 AF

300 5 AF 2.5 AF

650 10 AF 5 AF

Only use recommended fuse

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

Keine Kommentare

Elinchrom RX 1200 Betriebsanleitung Seite 9